Created the protogo USB on a 2013 15" MBP i7.
Expected behavior: When clicking "check computer", it should queue and run all tests by default. It does so when run from the normal application install on the host Mac.
When booted from USB on any other machine (15" MBPs 2013 and newer in my case) and all tests are selected, it instead runs ONLY the first one (memory test) and then stops. If you uncheck memory test, it fails to do anything at all when "run check computer" is clicked. This is due to the "video memory" test. When this is unckecked and "run check computer" is clicked, all tests queue and run normally. Video memory test cannot be run manually either.
It took a lot of troubleshooting to figure this bug out. Is it choosing the wrong GPU to test? Can it handle dual-GPU systems? Techtool 8 handles everything fine and works every time.
Techtool Pro 11 build 5280
Expected behavior: When clicking "check computer", it should queue and run all tests by default. It does so when run from the normal application install on the host Mac.
When booted from USB on any other machine (15" MBPs 2013 and newer in my case) and all tests are selected, it instead runs ONLY the first one (memory test) and then stops. If you uncheck memory test, it fails to do anything at all when "run check computer" is clicked. This is due to the "video memory" test. When this is unckecked and "run check computer" is clicked, all tests queue and run normally. Video memory test cannot be run manually either.
It took a lot of troubleshooting to figure this bug out. Is it choosing the wrong GPU to test? Can it handle dual-GPU systems? Techtool 8 handles everything fine and works every time.
Techtool Pro 11 build 5280